Click on the image to check the artwork
Feature :
The YTA510 is the high performance temperature transmitter that accepts Thermocouple, RTD, ohms
or DC millivolt inputs. YTA510 transmit not only process variables but also the setting parameters
using wireless signal. The transmitters run on internal batteries, and the installation cost can be decreased
since hard-wiring is not required. The communication is compliant with ISA100.11a protocol specifications.
These devices will be used with YFGW710, FieldWireless Integrated Gateway. As for YFGW710
specifications, refer to GS 01W01F01-01EN.
Specifications :
Input
Input type is selectable: Thermocouples, 2-, 3-, and
4-wire RTDs, ohms and DC milivolts. See Table 1.
Input Signal Source Resistance (for T/C, mV)
1 kΩ or lower
Input Lead Wire Resistance (for RTD, Ohm)
10 Ω per wire or lower
Output
Wireless (ISA100.11a protocol) 2.4 GHz signal.
Range
See Table 1.
Update Period
1 to 3600 sec selectable.
Zero-gain Adjustment
Set the amount of zero-gain point adjustment.
Integral Indicator (LCD display)
5-digit numerical display, unit display and bar graph.
The indicator is configurable to display the following
variables periodically.
°C, K, °F, °R, mV and ohm, 0 to 100 % bar graph
See also “Factory Setting.”
Sensor Burnout
Select either HIGH or LOW as the configuration.
Self Diagnostics
Amplifier failure, sensor failure, configuration error,
battery alarm, wireless communication alarm and
over-range error for process variables.
Software Download Function
Software download function permits to update
wireless field device software via ISA100.11a wireless communication.
Teachnical parameters :
Products show :
Why chose us :
